Videojet 1650 / 1650 UHS / 1550
Videojet E6071: No Time to Phase
Quick answer
Videojet E6071 means The printer does not get enough time between prints to run its phasing check..
What it means
The printer does not get enough time between prints to run its phasing check..
This page is generated from a public source (see below). It is a starting point, not a substitute for the service manual for your exact model and serial number.
Likely causes
- Product detector and printhead positions wrong for line speed
- Prints too close together
What to check
- Check the product detector and printhead positions
- Ensure enough time between prints to phase
- Use the service manual or call a Videojet engineer
Parts and consumables
Parts
- product detector
- printhead
Consumables
- Not listed in the source.
FAQ
What does Videojet E6071 mean?
Videojet E6071 (No Time to Phase) means: The printer does not get enough time between prints to run its phasing check.
What should I check first for Videojet E6071?
Start with: Check the product detector and printhead positions. Then: Ensure enough time between prints to phase. Then: Use the service manual or call a Videojet engineer.
When should I call a technician for Videojet E6071?
If the code returns after the checks above, or the printer develops a new fault, call a qualified technician.
Source: https://oeelab.com/videojet-printer-fault-codes — § E6071: No Time to Phase “E6071: No Time to Phase”.
Provenance tier: third-party source, not verified against the manufacturer manual. Confidence: low. Diagnostic guidance only — always verify against the manual for your exact model.