Videojet 1650 / 1650 UHS / 1550

Videojet E6029: EHT/HV Calibration Required

Videojet third-party source Checked 2026-11-21
Quick answer Videojet E6029 means The printer needs an EHT/HV calibration before it can run correctly..
Safety. EHT (extra-high tension) is present in the printhead; ensure it is clean and dry and the sleeve is secure before calibration.

What it means

The printer needs an EHT/HV calibration before it can run correctly..

This page is generated from a public source (see below). It is a starting point, not a substitute for the service manual for your exact model and serial number.

Likely causes

  • Calibration lost or not done (e.g. after a part change)

What to check

  1. Check the printhead is clean and completely dry
  2. Check the printhead sleeve is in place and secured
  3. Calibrate EHT/HV or call a Videojet engineer

Parts and consumables

Parts

  • printhead
  • printhead sleeve

Consumables

  • Not listed in the source.

FAQ

What does Videojet E6029 mean?

Videojet E6029 (EHT/HV Calibration Required) means: The printer needs an EHT/HV calibration before it can run correctly.

What should I check first for Videojet E6029?

Start with: Check the printhead is clean and completely dry. Then: Check the printhead sleeve is in place and secured. Then: Calibrate EHT/HV or call a Videojet engineer.

When should I call a technician for Videojet E6029?

If the checks above do not clear the code, or the fault involves a board, pump, valve, heater, or EHT/HV component, stop and call a qualified technician. Do not keep a production line running on an unresolved fault.

Source: https://oeelab.com/videojet-printer-fault-codes — § E6029: EHT/HV Calibration Required “E6029: EHT/HV Calibration Required”. Provenance tier: third-party source, not verified against the manufacturer manual. Confidence: low. Diagnostic guidance only — always verify against the manual for your exact model.