Videojet 1580 / 1860 / 1880

Videojet E15006: Viscometer Fault

Videojet manual Checked 2026-11-21
Quick answer Videojet E15006 means The viscometer was not empty at the start of the viscosity control cycle..

What it means

The viscometer was not empty at the start of the viscosity control cycle..

This page is generated from a public source (see below). It is a starting point, not a substitute for the service manual for your exact model and serial number.

Likely causes

  • Viscometer not empty
  • High or low probe shorted to ground
  • Defective IMB

What to check

  1. Contact your local Videojet Service representative

Parts and consumables

Parts

  • viscometer
  • ink management board

Consumables

  • ink

FAQ

What does Videojet E15006 mean?

Videojet E15006 (Viscometer Fault) means: The viscometer was not empty at the start of the viscosity control cycle.

What should I check first for Videojet E15006?

Start with: Contact your local Videojet Service representative.

When should I call a technician for Videojet E15006?

If the checks above do not clear the code, or the fault involves a board, pump, valve, heater, or EHT/HV component, stop and call a qualified technician. Do not keep a production line running on an unresolved fault.

Source: https://cdn.pimber.ly/public/asset/raw/604204e33fc1d2001bbaeea6/d48fefc9/62b5db2d2d2f5f4727000086/E12907_1.pdf — p. 9-13 “(E15006) Viscometer Fault”. Provenance tier: manual. Confidence: high. Diagnostic guidance only — always verify against the manual for your exact model.