Videojet 1580 / 1860 / 1880
Videojet E10672: Printhead 1 Valve Current Offset Out of Range
Quick answer
Videojet E10672 means The printhead valve current offset measured at start-up is outside tolerance..
What it means
The printhead valve current offset measured at start-up is outside tolerance..
This page is generated from a public source (see below). It is a starting point, not a substitute for the service manual for your exact model and serial number.
Likely causes
- Erroneous offset calculated at boot
- Environmental extreme
- Short in one or more valves
- Defective MCB
What to check
- Power-cycle to reset the offset
- Run a hardware self-test or valve test
Parts and consumables
Parts
- printhead valves
- main control board
Consumables
- Not listed in the source.
FAQ
What does Videojet E10672 mean?
Videojet E10672 (Printhead 1 Valve Current Offset Out of Range) means: The printhead valve current offset measured at start-up is outside tolerance.
What should I check first for Videojet E10672?
Start with: Power-cycle to reset the offset. Then: Run a hardware self-test or valve test.
When should I call a technician for Videojet E10672?
If the checks above do not clear the code, or the fault involves a board, pump, valve, heater, or EHT/HV component, stop and call a qualified technician. Do not keep a production line running on an unresolved fault.
Source: https://cdn.pimber.ly/public/asset/raw/604204e33fc1d2001bbaeea6/d48fefc9/62b5db2d2d2f5f4727000086/E12907_1.pdf — p. 9-7 “(E10672) Printhead 1 Valve Current Offset Out of Range”.
Provenance tier: manual. Confidence: high. Diagnostic guidance only — always verify against the manual for your exact model.